|
CAV-15
MKII Build Instructions
Your
receiver carries a lifetime replacement warrantee, if it is
determined your receiver broke due to normal use, we will replace
it for free. If your receiver breaks due to abuse or negligent
use, there will be a nominal fee ($30.00 plus shipping).
Cavalry
Arms recommends that you have a factory certified CAV-15 Armorer
or competent gunsmith assemble your stripped CAV-15 MKII receiver.
If it is determined that damage or function issues are a
result of improper assembly all warranties will be voided.
Notes
to Gunsmiths and Armorers:
- Takedown
Pins:
Use the supplied speed pins to secure your upper
receiver to your CAV-15 lower receiver.
If you lose or misplace the supplied pins, replacement
pins can be ordered from Cavalry Arms at a cost of $5.00 a
piece.
- The
CAV-15 MKII lower receiver uses a carbine buffer and spring.
- The
CAV-15 MKII lower receiver uses standard mil-spec fire
control pins.
Though the area of the receiver that accepts the hammer
pin is wider than aluminum AR15 receivers, it uses a standard
fire control pins.
Simply center the pin in the hole, and ensure it
catches on the J-pin in the hammer.
- Check
all pinholes before you Assemble gun! Parts vary slightly
between manufacturers and some parts may fit tighter than
others, especially the safety selector detent.
- Safety
selector detent pin/spring load from the top. The spring may
need to be trimmed for proper fit.
The top of the detent should sit at 0.20” (+/- 0.020)
from the base of the selector hole.
- Bolt
hold open spring will need to be trimmed 1 to 1½ coils for
the last round hold-open to function with older/weak
magazines.
- The
5/64th roll pin attached to this sheet is to
capture your buffer detent pin and spring.
For
questions regarding assembly or information on becoming a Cavalry
Arms Corp certified CAV-15 Armorer, call us at 480-833-9685 or
e-mail questions@cavalryarms.com
|
